Priscillas Bowl continued

Hi Everyone,
Its really cold this morning after last nights snow extravaganza so I just went out for a little while today to work on Priscillas bowl. Youll recall that the exterior needed its finish sanding done and then it needs to be hollowed out and here are a couple of photographs about that.
Fine grain woods like maple will finish beautifully but they require a lot of sanding to get to that point. This bowl has a lot of beautiful grain patterns but it also has some torn grain on the end grain ends that has to be sanded smooth. You can dry sand it or you can wet the surface down with mineral spirits:

This will really help smooth down the surface and get rid of small, micro scratches and torn grain. It also lets you see what the final color of the bowl will be. It also dampens down the dust from sanding. The next two photos show the bowl during this process:

Ive sanded the surface to 400 grit and then polished it with 0000 steel wool. Its now time to flip it over and begin hollowing it out.

Here is a photo of my trusty Nova chuck attached to the foot of the bowl ready to be attached on the lathe:

And here it is on the lathe. Im going to use my roughing gouge to remove most of the interior. Once thats done Ill switch to a bowl gouge:

Hollowing a bowl is a gentle process that is akin to sculpting. If you find that you are really working hard to cut the wood, either your gouge is dull or youre setting yourself up for a catch, which can knock the bowl off the lathe and is upsetting to have happen. Slow down and enjoy the process.

Here is a photograph of the outside of the rim of the bowl. I want to keep that crisp, clean line so Im going to be staying away from that area for now and just concentrate my attention on the center area of the interior of the bowl:

And here is the bowl after about 15 minutes of turning. Its about half empty at this point:

You can see the pile up of wood shavings at the base of the bowl. After its done and before I take it off the lathe for finishing, Ill take big handfuls of the shavings and turn on the lathe to about 800 rpm and gently press the shavings into the spinning wood. This will give it a final polish that is really beautiful to see.

Ok, tomorrow we have more hollowing and the beginning of the finish process for the interior of the bowl.

See you then,

VW

About later

Author Description here.. Nulla sagittis convallis. Curabitur consequat. Quisque metus enim, venenatis fermentum, mollis in, porta et, nibh. Duis vulputate elit in elit. Mauris dictum libero id justo.

Subscribe to this Blog via Email :